Sat, 31 Jul 2021 15:44:20 +0200
Version 0.3.19. Real sensors and code cleanup.
menu "BrewBoard Configuration" choice TEMP_SENSORS prompt "Select Temperature Sensors" default TEMP_SENSORS_ONEWIRE help Select to use Real or Fake Temperature Sensors config TEMP_SENSORS_ONEWIRE bool "Real Sensors" help Select this to use real Sensors connected on the One-Wire busses config TEMP_SENSORS_SIMULATOR bool "Fake Sensors" help Select this to use Fake Sensors for development endchoice config ONE_WIRE_MLT int "OneWire MLT GPIO number" range 0 34 default 27 depends on TEMP_SENSORS_ONEWIRE help GPIO number (IOxx) to access the DS18B20 for the MLT and Boil kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used. GPIOs 35-39 are input-only so cannot be used to drive the One Wire Bus. config ONE_WIRE_HLT int "OneWire HLT GPIO number" range 0 34 default 26 depends on TEMP_SENSORS_ONEWIRE help GPIO number (IOxx) to access the DS18B20 for the HLT kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used. GPIOs 35-39 are input-only so cannot be used to drive the One Wire Bus. config SSR_MLT_GPIO int "MLT SSR GPIO number" range 0 34 default 32 help GPIO number (IOxx) to the SSR for the MLT kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. config PWM_MLT_GPIO int "MLT PWM GPIO number" range 0 34 default 0 help GPIO number (IOxx) to the PWM pin for the MLT kettle. This is used for systems that can control the heating using a PWM signal. A Hendi induction cooker for example. Even when not used, this pin must be defined. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive PWM. GPIOs 35-39 are input-only so cannot be used as PWM outputs. config SSR_HLT_GPIO int "HLT SSR GPIO number" range 0 34 default 33 help GPIO number (IOxx) to the SSR for the HLT kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. config SSR_PUMP_GPIO int "PUMP SSR GPIO number" range 0 34 default 12 help GPIO number (IOxx) to the SSR for the Pump. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. config BUZZER_GPIO int "Piezo Buzzer GPIO number" range 0 34 default 25 help GPIO number (IOxx) to the Piezo Buzzer. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. endmenu