Fri, 26 Oct 2018 22:19:48 +0200
Version 0.2.6. Removed dead code in the tft component.
menu "BrewBoard Configuration" choice TEMP_SENSORS prompt "Select Temperature Sensors" default TEMP_SENSORS_ONEWIRE help Select to use Real or Fake Temperature Sensors config TEMP_SENSORS_ONEWIRE bool "Real Sensors" help Select this to use real Sensors connected on the One-Wire busses config TEMP_SENSORS_SIMULATOR bool "Fake Sensors" help Select this to use Fake Sensors for development endchoice config ONE_WIRE_MLT int "OneWire MLT GPIO number" range 0 34 default 27 depends on TEMP_SENSORS_ONEWIRE help GPIO number (IOxx) to access the DS18B20 for the MLT and Boil kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used. GPIOs 35-39 are input-only so cannot be used to drive the One Wire Bus. config ONE_WIRE_HLT int "OneWire HLT GPIO number" range 0 34 default 26 depends on TEMP_SENSORS_ONEWIRE help GPIO number (IOxx) to access the DS18B20 for the HLT kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used. GPIOs 35-39 are input-only so cannot be used to drive the One Wire Bus. config SSR_MLT_GPIO int "MLT SSR GPIO number" range 0 34 default 33 help GPIO number (IOxx) to the SSR for the MLT kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. config SSR_HLT_GPIO int "HLT SSR GPIO number" range 0 34 default 32 help GPIO number (IOxx) to the SSR for the HLT kettle. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. config SSR_PUMP_GPIO int "PUMP SSR GPIO number" range 0 34 default 12 help GPIO number (IOxx) to the SSR for the Pump. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. config BUZZER_GPIO int "Piezo Buzzer GPIO number" range 0 34 default 25 help GPIO number (IOxx) to the Piezo Buzzer. Some GPIOs are used for other purposes (flash connections, etc.) and cannot be used to drive a SSR. GPIOs 35-39 are input-only so cannot be used as outputs. endmenu