diff -r 64886971967b -r 31f9d3e4a85f components/tft/tftspi.c
--- a/components/tft/tftspi.c	Mon Feb 19 15:07:28 2024 +0100
+++ b/components/tft/tftspi.c	Mon Jun 24 17:05:20 2024 +0200
@@ -606,14 +606,14 @@
 void stmpe610_Init()
 {
     stmpe610_write_reg(STMPE610_REG_SYS_CTRL1, 0x02);        // Software chip reset
-    vTaskDelay(10 / portTICK_RATE_MS);
+    vTaskDelay(10 / portTICK_PERIOD_MS);
 
     stmpe610_write_reg(STMPE610_REG_SYS_CTRL2, 0x04);        // Temperature sensor clock off, GPIO clock off, touch clock on, ADC clock on
 
     stmpe610_write_reg(STMPE610_REG_INT_EN, 0x00);           // Don't Interrupt on INT pin
 
     stmpe610_write_reg(STMPE610_REG_ADC_CTRL1, 0x48);        // ADC conversion time = 80 clock ticks, 12-bit ADC, internal voltage refernce
-    vTaskDelay(2 / portTICK_RATE_MS);
+    vTaskDelay(2 / portTICK_PERIOD_MS);
     stmpe610_write_reg(STMPE610_REG_ADC_CTRL2, 0x01);        // ADC speed 3.25MHz
     stmpe610_write_reg(STMPE610_REG_GPIO_AF, 0x00);          // GPIO alternate function - OFF
     stmpe610_write_reg(STMPE610_REG_TSC_CFG, 0xE3);          // Averaging 8, touch detect delay 1ms, panel driver settling time 1ms
@@ -761,7 +761,7 @@
     if(ms) {
       ms = *addr++;              // Read post-command delay time (ms)
       if(ms == 255) ms = 500;    // If 255, delay for 500 ms
-	  vTaskDelay(ms / portTICK_RATE_MS);
+	  vTaskDelay(ms / portTICK_PERIOD_MS);
     }
   }
 }
@@ -863,11 +863,11 @@
 void TFT_PinsInit()
 {
     // Route all used pins to GPIO control
-    gpio_pad_select_gpio(PIN_NUM_CS);
-    gpio_pad_select_gpio(PIN_NUM_MISO);
-    gpio_pad_select_gpio(PIN_NUM_MOSI);
-    gpio_pad_select_gpio(PIN_NUM_CLK);
-    gpio_pad_select_gpio(PIN_NUM_DC);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_CS);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_MISO);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_MOSI);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_CLK);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_DC);
 
     gpio_set_direction(PIN_NUM_MISO, GPIO_MODE_INPUT);
     gpio_set_pull_mode(PIN_NUM_MISO, GPIO_PULLUP_ONLY);
@@ -877,17 +877,17 @@
     gpio_set_direction(PIN_NUM_DC, GPIO_MODE_OUTPUT);
     gpio_set_level(PIN_NUM_DC, 0);
 #if USE_TOUCH
-    gpio_pad_select_gpio(PIN_NUM_TCS);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_TCS);
     gpio_set_direction(PIN_NUM_TCS, GPIO_MODE_OUTPUT);
 #endif    
 #if PIN_NUM_BCKL
-    gpio_pad_select_gpio(PIN_NUM_BCKL);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_BCKL);
     gpio_set_direction(PIN_NUM_BCKL, GPIO_MODE_OUTPUT);
     gpio_set_level(PIN_NUM_BCKL, PIN_BCKL_OFF);
 #endif
 
 #if PIN_NUM_RST
-    gpio_pad_select_gpio(PIN_NUM_RST);
+    esp_rom_gpio_pad_select_gpio(PIN_NUM_RST);
     gpio_set_direction(PIN_NUM_RST, GPIO_MODE_OUTPUT);
     gpio_set_level(PIN_NUM_RST, 0);
 #endif